60 gram lead adhesive bar, divided into 4 x 5 gram and 4 x 10 gram sections. Total height of the balancing weight with adhesive tape 5.0 mm, width 15 mm. NOTE: This adhesive weight does NOT comply with the EU End-of-Life Vehicle Directive 2000/53/EC and therefore may not be used on vehicles of the categories M1 and N1 within this EU directive. Made in Germany Why should you balance tyres at all? At a speed of 100 km/h the centrifugal force of a 10 g unbalance acts like the force of a sledge hammer. This makes wheels without balancing weights a danger: Without adhesive weights on steel and aluminium rims, wheel suspensions and bearings are subjected to greater stress. Missing balancing weights on steel and aluminium rims can also lead to noticeable vibrations at the steering wheel and in the interior. In addition, non-existent adhesive bars result in increased brake and tyre wear. Assembly of adhesive weights: Basically the rim surface must be free of grease, silicone, dust and dry before mounting the adhesive weights. The processing temperature of the adhesive weights must not fall below 10 °C and the surface for attachment to the rim must not exceed a maximum bevel of 15 °C from the hub direction. Then select the required grammage of the adhesive weights and, if necessary, separate the balancing weights from the adhesive bar or the adhesive weight roll. Then carefully bend the adhesive weight slightly smaller than the rim radius and adjust to the rim radius.
adhesive weight Hofmann Power Weight -Typ 303- 60 g, Lead, grey
passenger car, motorcycle
List type rim
4×5g + 4×10g
100 piece / cardboard box